View Single Post
      02-26-2011, 10:27 AM   #9
hlmiii
First Lieutenant
 
Drives: '11 1M '10 M5 '06 M3 '10 670SV
Join Date: Nov 2008
Location: Houston

Posts: 377
iTrader: (0)

Quote:
Originally Posted by JIO View Post
There are two green wires up there. Be sure to chose the closest to the driver's side. One green wire works, the other doesn't.
THIS is the key. Absolutely correct.

They are very similar. It's not like prior generations.
Go with what you think is correct. If that does not work then just try the other one. You will get it correct, and you won't hurt anything.

As to the ground screw/bolt ... that's easy. Don't use that motor/Torx screw. Use the bolt that is a little difficult to reach. Loosen it, loop the wire or the spade around it and tighten.

Good luck.
hlmiii is offline   United_States
0
Reply With Quote