View Single Post
      12-09-2010, 01:57 PM   #1
SV Concepts II
SV Concepts II's Avatar
United_States
129
Rep
6,095
Posts

 
Drives: E90 M3
Join Date: Dec 2008
Location: 1460 White Oaks Rd. Suite F Campbell, CA 95008

iTrader: (7)

Jlevi SW | Active AutoWerke Performance Software for the S65 Engine



For pricing and ordering information, please visit the link below or contact us directly.





Greetings all,

JleviSW is proud to announce that we now offer Active Autowerke ECU Software Tuning in house.

No longer do customers in Northern California have to FedEx their ECU to Florida to get this high performance software installed. Those who do not have a local AA dealer will have to remove and ship their ECU to AA in Miami, FL for reprogramming.

For detailed instructions on how to remove your ECU properly for shipment, please reference the below link.

http://activeautowerke.com/pdf/product85.pdf

Active Autowerke now offers unparalleled performance software for all 2008 on BMW E9X M3 that uplifts the V8 4.0 liter to new levels in BMW performance tuning. Through careful remapping of the factory BMW DME tables, various elements such as ignition timing, fuel delivery, and part throttles are reworked to create performance gains. On some of the BMW V8 M3s, there are inherent situations of a rough, cold start idle that makes for poor drivability. With the new Active Autowerke software, the camshaft vanos tables are also re-mapped to eliminate this rough idle scenario to a smoother, cold start idle. The Active Autowerke upgraded software is designed to operate with gasoline that has an average octane rating with full emissions to create a clean burning combustion with good AFRs all within factory specifications.

The RPM limiter for each gear is also replaced to a higher range with the speed limiter also removed . These are all designed to work in unison for maximum performance.

In addition, 6MT owners can benefit from an aggressive launch control feature. The stationary RPM limiter on the stock ECU is the same as the actual RPM limit. AA reprograms the stationary RPM limiter to be held at a constant rate until the car starts to move. This results in a feature similar to the launch control mode featured on the DCT transmissions. The RPM threshold can be varied, but Active recommends a 4000 rpm for this Launch Control.

Performance Specs:
15 HP @ 8400 RPMS - Rear wheel HP measured on the dyno
11 Ft / LBs @ 6700 RPMs - Rear wheel FT/LBs measured on the dyno



  • Top Speed Limit Removed
  • Reprogrammed torque management
  • Remapped throttle response
  • Reprogrammed ignition, vanos and fuel parameters for maximum performance
  • Tune can automatically adapt to bolt on mods such as Intake & Exhaust
  • FULL control over DME fuel curve on LOCKED or OPEN DME
  • Modified VANOS camshaft remapping eliminating rough COLD start enable
  • Raised RPM thresholds in specific gears
  • Aggressive LAUNCH CONTROL feature for 6MT owners

Video Demo of the Remapped AA Launch Control Feature




Off road custom tunes also available for those running with deleted cats.


Supported Models:
2008-2011 E9X M3s with the S65B40 Engine & MSS60 ECU

Please contact us directly to schedule an appointment for on-site reflash.

Last edited by SV Concepts II; 08-10-2011 at 05:25 PM.