Well, I attempted this and royally screwed it up. Getting the LED out was a pita, I screwed up and cut the wires, got everything into the ZHP knob, re-spliced the wires, did a lousy job on drilling the hole, and then when I installed the knob it wouldn't go all the way on (wires) and I beat the emblem all sorts of crooked... Not to mention I got glue seepage. Royal fail on my part.
I'm going to order another ZHP knob and just run it illuminated, it is a nicer driving experience than the stock knob.
Last edited by Alex1911; 07-15-2010 at 08:24 PM.