View Single Post
      06-02-2010, 10:18 AM   #62
gixxer_kidd
Major
 
Drives: e92 m3
Join Date: Dec 2008
Location: NNJ

Posts: 1,401
iTrader: (11)

Garage List
2008 m3  [5.00]
Quote:
Originally Posted by elp_jc View Post
Yep. Let me add something that could help you, but it'd be risky: If you remove the 'cap' (where the shift pattern is), there's a torx screw at the bottom, and you could theoretically lift the whole lighting assembly, but you'd still have to widen the holes for the wires to extract them without cutting them (terminals are wider than the wires).
That's what I did. I lifted the cap then I lifted the led board. It took me a while but I managed to wiggle it out. Next I unscrewed the torx screw and lifted the entire lighting assembly out. After removing the wires from the connector I was able to pass them through the existing holes without enlarging it. So for me no cutting of the stock knob was required.

I just received the zhp knob yesterday so now I'm going to do the swap. A little unsure on where to drill and how much material to take off the top of the knob. Guess I'll take it slow and follow the directions here.
gixxer_kidd is offline  
0
Reply With Quote