View Single Post
      04-23-2010, 06:27 PM   #1
BimmerPost Supporting Vendor
EAS's Avatar

Drives: VF620 M3
Join Date: Mar 2010
Location: Anaheim, CA

iTrader: (10)

▀▄ eas | DIY: Macht Schnell - Competition Stud Conversion Kit Installation

Step 1
Jack up the vehicle and secure it on jackstands.Unbolt the lug bolts.

Step 2
Remove wheel from hub.

Step 3
Remove wheel and clean hub of all dirt and/or surface rush with a wire wheel to ensure a clean and flush surface. [optional]

Step 4
Apply loctite onto the end of the studs and hand tighten the studs onto the hub.

Step 5
Use an allen wrench to completely tighten the studs onto the hub.

Step 6
Put your wheel back on and torque down the wheel locks. Repeat for the other three wheels.

This is how it will look finished without the wheel on it yet(also has a spacer on it)