View Single Post
      04-22-2010, 03:54 PM   #7
GTM_Challenge
BimmerPost Supporting Vendor

 
GTM_Challenge's Avatar
 
Drives: E92 M3,X5M,F30 335
Join Date: Jan 2010
Location: Chicago

Posts: 2,714
iTrader: (7)

Send a message via AIM to GTM_Challenge
Quote:
Originally Posted by 808E90 View Post
I'm running a E92 Ericcson exhaust on my E90 and the tips stick out a lot (3-4 inches) ... I thought it would only be 1-2 inches and that I could make up some of the size with a diffuser but Ericcson tips are even longer ...

Should I cut them down and if so how?

Should I leave it a slap a diffuser on?

Should I cut and slap on a diffuser?

my advice would be this:

Here we would take the exhaust off, and cut a section out before the tip, then reweld the titanium exhaust. This way you wont harm the tips and any non-oem looking welds wouldnt be seen. Do you have anyone in HI that can do this for you?
GTM_Challenge is offline   United_States
0
Reply With Quote