View Single Post
      04-13-2010, 03:09 PM   #35
Bob MG
Moderating
 
Bob MG's Avatar
 
Drives: like a muppet
Join Date: Oct 2009
Location: Vienna

Posts: 1,766
iTrader: (0)

Gents I will be finished with my VT2 kit on Friday.
Instead of the 100mm pulley which boosts 5,5psi,
Roman supplied a 95mm pulley good for 6,5-7psi at sea level.

Based on the calculated loss of 0,17 bar or 2,46psi at 5000 ft, I would be safe to assume that my boost pressure will be between 4,0-4,5psi.

If it's closer to 4psi after dyno, we may contemplate a 92mm Which is normally a 7,5psi pulley at sea level.
92mm is the smallest pulley you can use with the VT blowers without changing belts and software.

Practical will be better than this speculation
Bob MG is offline   Greenland
0
Reply With Quote