View Single Post
      06-04-2009, 11:53 PM   #7
attbimmer
Second Lieutenant
 
attbimmer's Avatar
 
Drives: '13 991S, '88 E30 M3
Join Date: Dec 2007
Location: socal

Posts: 248
iTrader: (5)

Quote:
Originally Posted by attila View Post
I could get -1.2 on the front both side without the pins removed. My BMW service refused to remove the pins since " it is not recommended by BMW". I feel some change, mainly because i was running neutral and positive on one side!! as a factory setup. Would like to find an independent shop to pull the pins out and max - camber.
I am not convinced by the Dinan camber plates. An extra -0.5 degree for $500??!!!
Removing the pins is fairly simple. You just need to remove the plastic covers that hold the micro filter and then remove the strut braces. I did it a few weeks ago.

Regarding the Dinan camber plates they are only $250, not $500 (unless that was with labor), and they add -0.7 degrees. They are not adjustable (and will slightly raise the cars front ride height, but are a fairly common way to cheaply add negative camber.
__________________
attbimmer is offline  
0
Reply With Quote