View Single Post
      03-19-2009, 11:26 PM   #3
doba_s
Major General
 
doba_s's Avatar
 
Drives: M3, 1M
Join Date: Sep 2006
Location: San Francisco

Posts: 6,101
iTrader: (26)

Send a message via Skype™ to doba_s
21. Since OBDII port doesn't have two needed wire to connect A1 and A2 I decided to use cigaret lighter as the power source. I have something else taped into this power source so don't pay attention to the Red and Black wires. You need to tap A2 Braun wire in to thick Braun wire and A1 Green/Braun into thick Red/Black wire on your cigaret lighter connector.





22. Now you can put everything back together. Connect your battery after you are done with everything, start your car and you should get this





Read the Manual that came with your new PSW to set it the way you like !

I hope this will help

PDF FILE HERE
Attached Images
File Type: pdf perf wheel instructions.pdf (731.1 KB, 2644 views)

Last edited by doba_s; 03-20-2009 at 12:54 AM.
doba_s is offline   United_States
0
Reply With Quote