View Single Post
      11-30-2008, 05:20 PM   #2
monsta
Brigadier General
monsta's Avatar
United_States
59
Rep
3,591
Posts

 
Drives: E92 M3
Join Date: Oct 2006
Location: Bergen County, NJ/Y.O, NY

iTrader: (2)

my dealer installed a emblem w/ there logo on it.....my procedure was this....

Sprayed badge w/ water then took dental floss and ran it through the back and it came right off, I had a hair dryer ready if it didn't work to heat up the badge and melt the glue but it wasn't needed in this case but for the ///M3 emblem you may need it, now if you have a little glue residue left over just wipe done w/ a digreaser or in my case Simple Green.

I'm 100% sure you get it off w/ little effort so don't put too much elbow grease into also becareful not to let it drop and chip your paint

HTH

you need to put the black and white emblem on your car to complete your look
__________________

'08 E92 M3 6MT | IB | FR | RAC RG63's | VRS Ti Exhaust | Fabspeed HFC & Xpipe
'09 X5 35d SG/SB
'11 X3 28i AW/CN/FW (wife's car