View Single Post
      11-29-2008, 11:26 PM   #8
Stay Ripping
Drives: 1M
Join Date: Sep 2008
Location: New York

Posts: 422
iTrader: (4)

Originally Posted by mrrm3 View Post
For those of you who personally installed your UUC SSK, were you able to get the yellow plastic washer to fit on the selector rod pin and attach the C-clip? I am finding there isn't enough room on the pin and can't attach the C-clip unless I remove the yellow plastic washer.

Thanks for any input.

I also left the yellow washer off. I tried for 30 minutes, but it was impossible. The clip was on so tight without the washer that it was hard to rotate it.
I did not notice any washer when removing the stock shifter. I guess its their to snug up the clip.
TUNEDM3 is offline  
Reply With Quote