View Single Post
      11-25-2013, 09:09 PM   #3
CarbonAlpine
Lieutenant
 
CarbonAlpine's Avatar
 
Drives: 2011 M3
Join Date: Oct 2010
Location: Miami

Posts: 581
iTrader: (13)

Quote:
Originally Posted by C|3R1C View Post
No difference between years. I believe drain bolt is 6mm hex. 25-nm sounds about right. I believe the torque value for the filter is on the cap.
I just read the DIY again and realized the 25nm is for oil filter housing. The drain plugs are only 10nm...is this correct?
__________________
CarbonAlpine is offline  
0
Reply With Quote