View Single Post
      08-15-2013, 08:45 AM   #4
ERinEC
Private First Class
 
Drives: '11 AW E92 M3
Join Date: May 2012
Location: MD

Posts: 155
iTrader: (0)

Quote:
Originally Posted by ILSMKU View Post
I had a JL arkym rep lip from them that was too short on the sides (like 1/2" on each side) but fit like a glove and was very strong. I once parked into a curb stopper and it the lip picked my car up going over the curb. At the time it bugged me the sides were a tad too short. But the actual filament was pretty dam good around the curves of the bumper. It was dam near perfect.

I now have a arkym lip and its a JOKE. It meets the fenders edge, but its flimsy compaired to the JL lip. The filament SUCKS @#!*% on mine. Dealing with them is a joke! They told me to have it reinstalled and once it was confirmed my lip had issues, they wouldnt replace it because I had already installed it with set screws.

No lip is perfect so from now one I will only buy replicas. JL is pretty good stuff for the money. If I was to do it again, I would get the JL over the real one. I feel like I got ripped off with the Arkym.
Thanks for your input. That's a shame about the Akrym lip. I don't mind spending for a quality product, and believe in most cases, you get what you pay for, but it doesn't seem so with some of these exterior accessories.

I also read someone had purchased a type II Vorsteiner diffuser and the fit was not at all up to par. Hard to justify spending the extra coin unless I'm absolutely sure fitment is spot on.
ERinEC is offline  
0
Reply With Quote