Originally Posted by tom @ eas
Wiring should be the following:
PIN2 from Module >> PIN15 on EDC connector
PIN10 from Module >> PIN14 on EDC connector
PIN3 from Module >> Red wire removed from EDC connector (BMW harness)
PIN11 from Module >> Blue/Red Wire removed from EDC connector (BMW harness)
Power/Ground can be obtained from the white connector:
PIN1 = +12V Power
PIN6 = Ground
Hope this helps.
Sorry to revive an old thread but the top two connections above are the opposite of what the euro tuner article says:
PIN 2 >> PIN 14
PIN 10 >> PIN 15
Which is correct?