View Single Post
      05-29-2013, 03:32 PM   #131
You see, it's the principle of the whole thing...
BIGW0RM's Avatar

Drives: 2017 911 C2S
Join Date: Jul 2011
Location: ///OC

iTrader: (13)

Garage List
Originally Posted by MMM3PWR View Post
Just installed my new shift knob... Found it pretty simple, when you are fitting the new leather to your existing ring I found that if you pull the leather down until there is minimal slack around the edges then your ready to clamp and trim, then remove clips one by one and glue behind each clip replacing the clip after glue has been applied , repeat until all clips have been glued behind ... Pics to follow
I pushed my ring down as tight as it could go and going into reverse caused it to lift the base plate to unsnap.

So I wouldnt push that ring down too tight.
2017 ZCP DCT F80 M3 / 2017 991.2 PDK Porsche 911 S