View Single Post
      05-02-2013, 04:05 PM   #1
DLSJ5
Brigadier General
DLSJ5's Avatar
United_States
89
Rep
3,497
Posts

 
Drives: 08 E92 DCT M3
Join Date: Dec 2006
Location: CA

iTrader: (1)

Send a message via AIM to DLSJ5
ESS VT3 Supercharger - EAS Dyno Results - 703WHP / 478WTQ STD and 685WHP / 466WTQ SAE

BIMMERPOST
     Featured on BIMMERPOST.com
Hey guys, I took the car down to EAS today to have Tom and Steve dyno the car, this time with a slightly smaller pulley, ~1psi more than before. ESS and I have developed the car in stages, starting with a modest 10 psi, then 12, and now 13.5psi, well today the car hit 700whp STD, 685SAE.

We could probably go with more boost, but this blower is most likely maxed out at 13-14psi. The DCT is holding strong, AFR's are good on the in car gauge, high 11's to low 12's, this was on 11 gallons of 91/100 mix and 4 gallons of E85.

Robert will put together a full overview but for now here is the highest run today. I will also eventually dyno again at Specialty Z, another widely used dynojet in my area. It reads the same as EAS' dyno, in fact I hit exactly the same #'s on the previous, larger, pulley, 686 STD and 667 SAE, on both dyno's within a few weeks apart.





SPECIAL THANKS to: Anthony@EAS for the below vid and pics, AWESOME work as always!













__________________
08 E92 M3 DCT - Bolt Ons - 60-130MPH 10.71s - 11.88 @ 118MPH - 377WHP
ESS VT2-625 SC 60-130MPH 6.80s - 11.30 @ 129.3 MPH 586WHP / 379WTQ
ESS VT3-750 - 60-130MPH 6.44s - 10.81 @ 135.13 MPH 690Whp/463Wtq

Last edited by DLSJ5; 05-03-2013 at 02:47 PM.