View Single Post
      04-09-2013, 08:42 PM   #51
R0ME0
"Midas Touch"
 
R0ME0's Avatar
 
Drives: E86 ///M
Join Date: Aug 2007
Location: Seattle, WA

Posts: 471
iTrader: (9)

Quote:
Originally Posted by Fred@ReverseLogic View Post
I sell the blocks with bolts (or "pins") without the stands for $32. You need to drill a 10mm hole through the center of the saddle to attach the bolts. It's not really practical to try to do this with a hand held drill. You need a drill press at a minimum, but, it's easier if you have access to a lathe.

If you send me the inner tubes from your jack stands I can drill the holes for $10 per pair the next time I have the lathe set-up to run a pallet full of jack stand tubes.
When would the next run be if I sent my tubes in?
R0ME0 is offline  
0
Reply With Quote