View Single Post
      04-05-2013, 10:15 AM   #32
kiln
Lieutenant
 
kiln's Avatar
 
Drives: 2011 E90 M3
Join Date: Oct 2010
Location: New Orleans, LA

Posts: 441
iTrader: (6)

Send a message via AIM to kiln
Quote:
Originally Posted by BMRLVR View Post
I don't think many people here understand that this isn't a zero risk proposition. The bearing clearances on this engine are already too tight. And some of us believe that the bearing failures are caused by too little bearing journal clearance as it is (that explains why they all seem to fail very early in life). Adding a coated bearing will make it even tighter unless properly clearanced in advance. That's why VAC has the disclaimer at their web site that you must ensure proper clearance when using these bearings. The guys who just drop the pan and replace the bearings can't measure bearing clearance and may end up increasing their risk of failure, not lessening it.

Mike it would be helpful if you can touch on this.
* What are the factory bearing clearances?
* What is your recommended bearing clearance?
* How thick is the coating on your bearings?
* How does the coating affect the taper on the bearings?
* Do you send out a spec sheet for clearances with your bearings and/or do you send ot instructions how to measure and maintain proper clearance?
+1
kiln is offline   United_States
0