View Single Post
      03-10-2013, 09:27 PM   #1
Schom
Private
0
Rep
82
Posts

 
Drives: 2008 m3 e92 6mt
Join Date: Oct 2012
Location: Minnesooooota

iTrader: (0)

Whack'em with a mallet?

When changing out the m3 wheels, do they typically sticK? Am guessing no, with studs instead of lug bolts.

Seems like maybe a dumb question, but on my x5 the wheels were unbelievably difficult to separate from the rotor after the lugs were off and many dudes on the forum suggested hitting them with a mallet to break them loose. Was a common problem amongst other x5 owners, and that was a common solution.

Is a bit suspect with a 4500 lb truck on a jack doing this, and at that point Just said f it and took to the tire shop. Would like to swap my own in the m3. Curious if I'm in the same boat and just shouldn't even try.

My c4 cab with bolts also does this.