View Single Post
      02-05-2013, 07:29 PM   #142
Mike Benvo
BimmerPost Supporting Vendor

 
Mike Benvo's Avatar
 
Drives: 08 E90 M3 / 400whp Turbo 7
Join Date: Apr 2008
Location: SoCal

Posts: 4,647
iTrader: (7)

Garage List
2008 BMW M3  [5.00]
1990 BMW 735i Turbo  [5.00]
2004 BMW M3  [0.00]
Send a message via Skype™ to Mike Benvo
Ok - looks like there is some interest.

There was a customer that had his car dynoed before and after in North Carolina today. I'm excited for him to share the results. Nice gain in horsepower and torque on a car with stock primary cats, all the way through the range (Dynojet, with the 48" rollers). Also did a few other things, Euro DCT, Euro MDM etc..

jagman: GB price will be around $900 (For Stage I and II). This is for engine software only. DCT flashes are in person, until I have some time to test this with the cable and have 100% guaranteed success rates. I never release anything not fully tested. As far as being up in SF, I've been speaking with McKenna BMW and we might be offering a group buy up there.

SSJVegita: This is months out. Theoretically coding support could be added to the existing cables as well, so the existing ones might get coding support when the newer ones are released. I can't say for certain right now.

Any others that would like to join, please add your name to the list. Cables for the group buy will not be shipping until late March most likely because I need to address a huge backlog of 400+ emails and a couple other projects I've put on hold (F10 M5 and N55 tuning, and a few other things) before I take on round two of the group buy.

Thanks everyone!

List:
1. AyooooJay
2. clarity1
3. scoob4fun
4. RB1
5. m3p40
__________________

-----| Like us on Facebook | Instagram || Tuning Information | Remote Coding |-----
----Visit us at www.BPMSport.com - Emotion. Driven. | Toll Free: (888) 557-5133----
Mike Benvo is offline   United_States
0
Reply With Quote