View Single Post
      01-12-2013, 10:34 PM   #4
Zzhou
Lieutenant
 
Zzhou's Avatar
 
Drives: 2012 E92 SSII ZCP DCT
Join Date: Aug 2011
Location: West Lafayette,IN/Shanghai,China

Posts: 525
iTrader: (0)

Quote:
Originally Posted by M3_FJ View Post
If you have to put a hole for the tow hook i would suggest using a hole saw bit rather then "cutting" It will be much cleaner cut. What i did on my race bike to install frame sliders through the fairings was take a Sharpie marker, cut it down short, insert it into hole where frame bolt goes(marker tip facing out) and put fairing back on bike. Then press fairing onto marker, remove fairing and you know exactly where to put pilot hole for hole saw bit. You could apply same technique for bumper by inserting marker into tow hook hole. Time consuming yes but it will be a perfect cut and line up.
thanks a lot for the advice, I would let IND do it since they will be install my bumper.
__________________

AA Green Filter/AA Pulley/AA catless X-pipes/AA signature exhaust/AA TUNE/TMS studs/Project Kics R40/AD08/Vorsteiner GTS5 Bumper/LUX H8
Zzhou is offline  
0
Reply With Quote