View Single Post
      01-10-2013, 02:27 AM   #1
HP Autosport
BimmerPost Supporting Vendor

 
Drives: E82 1M
Join Date: Mar 2007
Location: Santa Barbara, AP, Brembo, GIAC, Koni, Ohlins, Quaife, Stoptech, Vorshlag

Posts: 10,992
iTrader: (29)

New Product - Swift Spec-R Sport Springs for your E9x M3

Swift made Sport Springs Spec-R is made for true track racing enthusiasts that wants to take their vehicle to the next level.
Sport Springs Spec-R is engineered with 2 main characteristics.

1 Redesign lowering ride height to maximize the suspension performance allowing the vehicle to fully absorb road condition for maximum traction.

2 Increase in spring rate to further enhance cornering speed through entry & exit. The increase in spring rate is based on the vehicle factory stock valving settings. Sport Springs Spec-R is increase to the optimal rate that the stock shocks can handle. Higher performance shocks are not required, but recommended.

Spec R springs are wound with the same engineering as our sports springs. With the exception of stiffer rates and slight change in ride height; you can expect the same characteristics as our sports springs.



H5S.TW

Motorsport's most advanced spring material


Swift made a name for itself on the tracks of Asia, Europe, and U.S. by defying all accepted concepts and speculations about the future, if any, in coil spring science.
When many other company were looking at expensive and brittle titanium composites to create the next evolution of springs, Swift was looking at reinventing the entire science of coil spring dynamics. Swift saw that most others are using the old regular silicone chrome material, which was not strong enough. It used a heat tempering method that damaged the strength of the material that requiring more coils, in turn, more weight.
The material was also suffering from a short life span. With springs like this leading the industries, Swift saw room for improvement.

Swift's R & D team created material, called H5S.TW, which is stronger then regular silicone chrome material. Because of this material, we could make the spring wire thinner, and could wind the springs with fewer coils, which greatly decreased weight while dramatically increasing available stroke.

M3 lowering:

1" in the front .75" in the rear.

Spring rate:

-5kg/mm in the front
-12kg/mm in the rear

More information here:

http://www.m3post.com/forums/showthr...8#post13283708

***Spring pictured only a generic Spec-R photo***
Attached Images
      

Last edited by HP Autosport; 04-17-2013 at 06:47 PM.
HP Autosport is offline   United_States
0
Reply With Quote