View Single Post
      12-31-2012, 10:44 PM   #38
Mike Benvo
BimmerPost Supporting Vendor
Mike Benvo's Avatar
United_States
98
Rep
4,813
Posts


 
Drives: Harrop SC M3 / E46 M3 / 7Turbo
Join Date: Apr 2008
Location: SoCal

iTrader: (7)

Garage List
2008 BMW M3  [5.00]
1990 BMW 735i Turbo  [5.00]
2004 BMW M3  [0.00]
Send a message via Skype™ to Mike Benvo
Quote:
Originally Posted by Vic311 View Post
Error code ..fault code???..when you scan for codes through the OBDII port..

The OP had "a" code he just never posted what it was, he referred to have the rev limiter reduced which indicated possible limp home mode
You posted "Ok so seems m3an had it correct that its a DSC type fault as opposed to engine..but it will through that fault code"

And I was just saying that I was unsure if you were referring to an engine fault code or DSC fault code with your use of 'that'.

Semantics at this point. It's not that it will throw a code if you spin out. It might and theoretically should not without extreme circumstances.

Codes scanned through the OBDII Port will be OBD II generic and will normally not show ANY DSC faults, unless you are using a specific tool designed for BMW bus systems and control units.
__________________

-----| Like us on Facebook | Instagram || Tuning Information | Remote Coding |-----
----Visit us at www.BPMSport.com - Emotion. Driven. | Toll Free: (888) 557-5133----