View Single Post
      12-06-2012, 02:37 AM   #26
Damon 808 State
Registered
0
Rep
3
Posts

Drives: 2008 E92 M3
Join Date: Nov 2012
Location: Hawaii

iTrader: (0)

Update: Bank 2 error this time...
It turns out that an intermediary connector that feeds the Bank 2 position sensor plastic clip was broken. This allowed the wire harness to become miss positioned and when the throttle bank 2 was in a fully opened state would rub against the wire harness stripping the insulation on the wire causing a Bank 2 position error. I replaced the Harness and used zip ties to hold in place. Sorry for the late update, but I wanted to make sure that this was in fact the fix.

Thanks again for all of the replies.