View Single Post
      09-09-2012, 08:32 PM   #5
m3an
Banned
 
m3an's Avatar
 
Drives: M3
Join Date: Oct 2010
Location: South Florida

Posts: 1,611
iTrader: (2)

OP there is nothing wrong w/ a competent shop removing a few mm (dependent on available room on hub) to decrease offset, don't listen to all the negatives here. Ask the wheel shop as they'll be the ones doing it. If it were me, I would try and roll the rear fenders slightly first. Cheaper and you're not messing w/ the wheels at all. Remember, ask the wheel shop as this method will vary dependent upon wheel
m3an is offline  
0
Reply With Quote