Originally Posted by OC ///M
Your post comes across as confrontational and is a little off-putting. BMRLVR was not attacking, rather, he was informing the community while showing rationale behind his question, Are you capable of, or have you successfully bored and honed an ausil block to factory specs?
You may have been working on BMW's for a while, but you're a relative newbie on this forum. "If you did not know..." BMRLVR (to put it mildly) has quite a bit of first-hand mass scale engine experience.
BMRLVR had no problems with my post. I have no problem with his. After I read his first reply I looked at his post history before I replied -pretty common practice.
In my first reply I said "We have the resources to offer any S65 solution" Is that not clear?