View Single Post
      08-19-2012, 02:41 PM   #6
Car54
Captain
 
Drives: 1999 Z3 Mcoupe | 2008 M3/4
Join Date: Sep 2007
Location: Lutz, FL

Posts: 837
iTrader: (1)

Quote:
Originally Posted by warp10motorsports View Post
Could you post some more detailed step by step?
There's not much to it.

Cut holes in the front, install inlets, connect 3" hose to the back, cut a hole in the wheel well liner, attach hose.

If you use the existing screw hole in the wheel well to line the port up, you'll be in the right spot.

The port comes into the wheel well about 3" higher than the front port.

I would suggest ordering some c-clip nuts ahead of time. Luckily I had a good variety on hand.

http://componentparts.co.uk/Spring%2...0Fasteners.htm
__________________

Craig Brickner
BM
W CCA/PBOC/Chin Motorsports DE Instructor
Click to Join: BMWCCA # 366493
Car54 is offline  
0
Reply With Quote