View Single Post
      08-03-2012, 03:28 AM   #2
Bully
New Member
 
Drives: 2009 Black M3 Vert
Join Date: Jan 2011
Location: Hendersonville, NC

Posts: 21
iTrader: (0)

Next I scribe the out line of the Vert switch with a hobby
knife. Then proceed to drill 44 holes with a micro hobby
bit 0.0745 inch ( 1.89 mm). The important issue here is not to drill at the scribe line but rather about 1/4 inch inside
to avoid having Carbon Fiber deflection /de-lamination problems. I then used a bigger drill .1065 inch ( 2.73 mm )
to reduce the gap between the holes for easier cutting.
Attached Images
   
Bully is offline   United_States
0
Reply With Quote