View Single Post
      07-17-2012, 01:08 PM   #116
ILSMKU
BMW FTW
 
ILSMKU's Avatar
 
Drives: E92 M3
Join Date: Jul 2011
Location: ///OC

Posts: 1,728
iTrader: (5)

Garage List
Quote:
Originally Posted by Technic View Post
- Record some 30Hz to 50Hz tones of about a minute in duration in a CD. There are several free MP3 tone generators in the Internetz.

- Set multimeter to VAC with a 50V range

- Play the CD and increase the volume until the output is maxed out or voltage exceeds 30V, whichever is first.

- That will be the output voltage of the OEM amp woofer outputs at the lowest frequencies/most power required.

Check again the LC2i settings, paying the most attention to this LC2i manual note:



I would suggest setting the iDrive OEM Bass adjustment and EQ bands to mid level or even less and then boost the bass using the AccuBass level control only if required. Just set the threshold control fully clockwise.

Make sure that you install a 1A fuse on both the LC2i 12V and the remote in (OEM remote signal). Messing around these devices can provoke a short circuit. And once the OEM remote signal is gone, it will be gone from your CIC...

Ok, thank you. I will run some tests when I get home to see what volts mine is spiking too.

My Accubass is OFF.

I have a 1amp fuse on the 12v, but not the remote. I will add one asap.
ILSMKU is offline   No_Country
0
Reply With Quote