View Single Post
      04-27-2012, 10:55 AM   #78
THE TECH
BimmerPost Supporting Vendor

 
THE TECH's Avatar
 
Drives: BPMsport 2012 E92 M3
Join Date: Jun 2011
Location: Kansas

Posts: 13,010
iTrader: (42)

Garage List
Send a message via AIM to THE TECH Send a message via Skype™ to THE TECH
Quote:
Originally Posted by VP Electricity View Post
I'm only referring to what Technic and I did in this project. The Tech is mistaken in this regard, I believe.

In the Stereo cars, the speaker interface isn't the issue, it's the correction.

But it's incorrect to say "all that's needed is the right harness". 97% of all aftermarket amplifiers sold are NOT compatible with the signal out of ANY BMW audio system with ANY harness. Even HiFi system signals are only usable by amps with balanced inputs.

A few amps can take the woofer signal directly in without distortion in a Logic 7/HK add-a-sub arrangement.

But most amps on the market are common-ground RCA input, and if they have a "speaker-level" input, it's a balanced input with a lot of attenuation in front of it (which usually ruins your noise floor with a lower-voltage preamp signal which needs no attenuation). Common-ground RCA input means the outer ring of the RCA is grounded, and this shorts the (-) clamped DC leg of the HiFi audio output.
Correct, you can skip the MS-8 but wasn't sure if it was the best way or not.
__________________
THE TECH is offline   United_States
0
Reply With Quote