View Single Post
      04-26-2012, 05:48 PM   #21
Drives: None
Join Date: Sep 2009
Location: None

Posts: 1,435
iTrader: (13)

Originally Posted by NJ 1161 View Post
I had same issue when fitting bbk. It turned out at the chap that was doing it was only bleeding the top valve, and that my kit had a nipple on the reverse side of the calliper as well. Bleed these as voila! Sounds obvious but have you checked for additional bleed valves??

Good point. I had fluid spilling out from additional valves during the first round. We have them all tightened down at the moment, so I think it is only about getting the air out of the system. Wish me luck chaps!
ajvee is offline  
Reply With Quote