View Single Post
      03-26-2012, 12:32 PM   #7
THE TECH
BimmerPost Supporting Vendor

 
THE TECH's Avatar
 
Drives: BPMsport 2012 E92 M3
Join Date: Jun 2011
Location: Kansas

Posts: 13,079
iTrader: (44)

Garage List
Send a message via AIM to THE TECH Send a message via Skype™ to THE TECH
It might make sense in the fact that we should technically only need the output of one speaker for the signal we need since this is a mono application. So is it possible that running both sets of speaker wires to the LC2i is causing TOO much voltage to run through the unit therefore killing it? If I had my car here today, I could use a DVM to check what the output is from the stock speakers.
__________________
THE TECH is offline   United_States
0
Reply With Quote