View Single Post
      03-23-2012, 06:47 PM   #31
tlp
Lieutenant Colonel
 
tlp's Avatar
 
Drives: '11 e92 M3 SG/FR
Join Date: Jul 2005
Location: Huntington Beach, CA

Posts: 1,880
iTrader: (6)

Garage List
2011 BMW e92 M3  [4.55]
Quote:
Originally Posted by Z K View Post
Does everyone set ride height based on collar threads?

I noticed that if the collars are even in front, one side is higher by about 1/2 inch over the other side. I had to drop the perch on one side so the ride height in front is even.

I've never seen this with any coilover install. Sometimes it is a little off when setting by collar height but 1/2 inch difference between left and right is quite a bit.

Is this normal for the Sleeve-over?
Assuming your off in the front. If that is the case then the perch got hammered into one strut more than the other. Its a friction fit and it can take a lot of pounding to get it fully seated. It's not the end of the world if they are off, just adjust it in the collar to level it out.

Last edited by tlp; 03-23-2012 at 08:36 PM.
tlp is offline   United_States
0
Reply With Quote