View Single Post
      03-05-2012, 04:15 PM   #114
THE TECH
BimmerPost Supporting Vendor

 
THE TECH's Avatar
 
Drives: BPMsport 2012 E92 M3
Join Date: Jun 2011
Location: Kansas

Posts: 13,104
iTrader: (45)

Garage List
Send a message via AIM to THE TECH Send a message via Skype™ to THE TECH
Quote:
Originally Posted by Technic View Post
Try the new LC2i first, with AccuBASS threashold full clockwise and AccuBASS gain at minimum from the beginning. Use the Bass output, GTO disabled and use a fuse at the 12V input of the LC2i.

If still not satisfied then contact forum member Mike Benvo, he can code your CIC remotely. I can provide you with the PnP RCA harness for the back as shown in the other thread.

Remember, you will need at least 8-channels of amplification and a DSP processor.
I already have a new one. The third one is on the way but I wasn't planning on opening it. You said GTO was automatically disabled when a remote wire is used. Do I need to change the jumper anyway?

I can go to Mike's house, so that's not an issue.

What do you recommend for a dsp? I would use JL HD amps for the 8-channels.
__________________
THE TECH is offline   United_States
0
Reply With Quote