View Single Post
      02-29-2012, 11:03 AM   #67
THE TECH
BimmerPost Supporting Vendor
United_States
205


 
THE TECH's Avatar
 
Drives: BPMsport 2012 E92 M3
Join Date: Jun 2011
Location: Kansas


Posts: 13,116
iTrader: (45)

Garage List
Send a message via AIM to THE TECH Send a message via Skype™ to THE TECH
Quote:
Originally Posted by Technic View Post
1) With car/iDrive OFF, open trunk and have a good look at the LC2i and your aftermarket amp. They should be ON.

2) Leave trunk opened, go away and come back in about 10 minutes.

3) Take a look at the LC2i and the aftermarket amp: they should be OFF.

4) Open the driver's door.

5) LC2i and the aftermarket amp should be ON.

That tests the OEM remote wire. GTO is irrelevant if you connected the thin black wire directly to the LC2i and then the LC2i remote out to the aftermarket amp.

1) Connect aftermarket amp inputs to the LC2i MAIN outputs.

2) Set LC2i gains (all of them) to min

3) Play a 50Hz tone and adjust LC2i MAIN gain until is loud enough for you from the driver seat.

That should be it.

Remember, the harness is only wires connecting the OEM amp woofer outputs to the LC2i high level inputs.
Will do. I know that steps 1-5 are good. I have monitored that several times. I will play with the settings some more and see.
__________________