Originally Posted by Brainofjjj
Can you think of anything that could have been installed wrong? I mean it's just spring and some height adjusters right.
That's what I thought too
I'm not tech, and I'm not technical by any means.... so take what I say with a grain of salt:
You know the top of the struts? where you EDC module is connected?
The problem with my install was that the bolts were tightened and the struts kept "in place" at the wrong "angle"
MRF loosened the bolts, used a measuring tape to make sure both sides were even, and then tightened them.
Then I was able to get my alignment.
I'll warn you again: I'm not technical, I'm bad at describing things.... so it's best to consult a real tech.
But this is the area in the install that went wrong on my car