View Single Post
      01-07-2012, 03:37 PM   #32
Tim B.
Lieutenant
 
Drives: 2010 Jet Black E92 M3
Join Date: Dec 2009
Location: Baton Rouge, LA

Posts: 544
iTrader: (0)

Quote:
Originally Posted by Mike Benvo View Post
Which part of the test did it fail?

Normally when the cat efficiency error is ignored in the ecu file, this prevents the readiness tests from leaving the "pending" or "not ready" states, which will cause an automatic fail in states that read the OBD monitors and require them to be ready.

There are some tricks to get around this but it's shaky territory in terms of federal emissions standards.


It says Catalyst "not ready", O2 sensor "not ready", Heated Cat. "not supported"
Readiness results: Not ready

No codes were found, but i'm not sure the software is just not "masking" them???
Tim B. is offline  
0
Reply With Quote