View Single Post
      11-09-2011, 11:05 PM   #31
tom @ eas
BimmerPost Supporting Vendor

 
tom @ eas's Avatar
 
Drives: BMW
Join Date: Nov 2005
Location: Anaheim, CA

Posts: 9,888
iTrader: (13)

Garage List
Quote:
Originally Posted by Brooklyn Mark View Post
What would be a cause for DBS and DSC malfunctions after the install?
Likely crossing the CAN high/low wires or low battery voltage. Make sure the wiring is correct before firing up the ignition.

Quote:
Originally Posted by Grant@DetailAddict View Post
So strange as I have the PSW v1 and tapped my Cig Lighter when I did the install.
Never had an issue with settings staying in memory.
Glad you guys solved your issue though
Quote:
Originally Posted by THE TECH View Post
Is it possible there's a difference in wiring for the pre-lci cars vs lci cars?
There are no settings to store in PSW1, therefore constant power was not necessary. PSWII is a bit more advanced.

There have been no changes in wiring (at least where steering wheel installation is affected) from pre-LCI to LCI.
__________________
Tom G. | european auto source (eas)
email: tom@europeanautosource.com web: www.europeanautosource.com tel 866.669.0705 ca: 714.369.8524 x22

GET DAILY UPDATES ON OUR BLOG FACEBOOK YOUTUBE FLICKR INSTAGRAM
tom @ eas is offline   United_States
0
Reply With Quote