View Single Post
      08-18-2011, 11:36 PM   #112
elp_jc
Brigadier General
United_States
79
Rep
4,910
Posts

 
Drives: .
Join Date: May 2008
Location: .

iTrader: (0)

Quote:
Originally Posted by k3silk View Post
2. Thin white led light board how to get it out
Once you have the black piece on the top right corner out, just remove the 2 terminals from the white connector and pull the white LED board out; that's all you need from the stock knob, so you can destroy the black piece if the wires give you a hard time . And of course mark which wire goes where on the connector, because after fishing the wires thru the modified ZHP knob, you'll have to reinsert them back in the correct position... but push the little tabs out first so they lock firmly in place. Needless to say, you'll need a very small jeweler's (flat) screwdriver for the connector job. Good luck.

PS: If somebody already removed the wires without marking them, just insert the empty connector into the female one on the car and mark them there .

Last edited by elp_jc; 08-18-2011 at 11:41 PM.