View Single Post
      08-02-2011, 09:37 AM   #66
snobdrak
Registered
 
Drives: '08 M3 Convertible
Join Date: Jul 2011
Location: Springfield, IL

Posts: 1
iTrader: (0)

Actually I don't think either require sanding, if you get them put on in just the right position. I found this out by accident. I put the new bulb on the plastic base to see how they fit together, saw that they needed to be shaved by a little bit and went to get a file. Before I started filing, I put them on the base one more time to make sure I knew what/where I was sanding and the bulb rotated right into position. When I went to do the second bulb, it looked again like it was going to need sanding, so on a hunch I took the bulb off and rotated it 180 degrees, and put it back on the base and it slid right into place. For reference, the bulbs I was using were the Amber WeissLicht bulbs.
snobdrak is offline  
0
Reply With Quote